Semi-automatic Splitting Machine
0102030405
Multi-group Multi-knife Cutting Machine
01
7 Jan 2019
1. Multiple groups of cutters from above and below are used for simultaneous segmentation.
2. The bottom of the equipment is installed with adjustable casters, which is convenient for the equipment to move, and to be stable and fixed when it is not need to move, and the height of the foot can be adjusted to more than 50MM.
3. Equipped with SMEMA interface can be connected with other equipment, there is a reserved network interface, and the following up intranet connection will be available.
4. Necessary safety precautions.
5. The equipment needs to be operated stabilized and it is necessary to have all components inspection.
6. According to the normal production capacity, it needs to reach up to 1500PCS/H or higher.
7. There are data monitoring and statistical outputs: boot time monitoring, capacity monitoring, equipment failure information and automatic rejection system, etc.
8. The distance between the above and below cutters can be accurately adjusted, and the thickness of the items needs to fulfill with 0.6mm-3.5mm.
9. The gap between the above and below cutters can be adjusted according to the V-CUT spacing of the PCB board, and the accuracy is controlled within 0.1mm.
Technical Parameters
| Multi-group multi-knife cutting machine | |
| Plate thickness | 0.2-3mm |
| Maximum board length | unlimited |
| Number of boards | 9 consecutive pieces |
| Number of slitting machine knives | 40 pieces |
| Power supply | single-phase AC230/110V 50-60HZ,40W |
| Machine size | L2160*W570*H1050mm |
| Splitting speed | 80,120,200,400mm/s adjustable |
| Net weight | 158Kg |
FAQ
Q: The knife hit the right side panel
A: 1. The right travel light sensor switch is broken and needs to be replaced.
2. Too much dust on the right travel switch will also cause collision. Just clean the dust.
Q: The knife hit the left side panel
A: 1. The left stroke light sensor switch is broken and needs to be replaced.
2. There is too much dust on the left travel switch. Just clean the dust.
Q: The motor rotates but the knife does not rotate.
A: The coupling jack screw is loose. Open the rear shell and tighten the jack screw.
Q: The indicator light does not light up after the power switch is turned on.
A: 1. Fuse segment, the fuse needs to be replaced
2. The emergency switch is not turned on.
Q: The itinerary is not accurate
A: 1. The stroke counter is broken and needs to be replaced.
2. There is too much dust on the stroke counter. Just clean the dust.